Table of Contents
Advertisement
REASSEMBLY AND ADJUSTMENT
FUJI GW690-111 (PROFESSIONAL)/FUJI GSW690-III (PROFESSIONAL)
14
Installing the shutter frame assembly (741)
a.
Match the hole (B) of the shutter frame assembly <741) with the groove (C) of the
hold ring (7-79), and install the shutter frame assembly (741) on the helicoid assembly
with three screws (7 46), (a) •
b.
Apply the gear shaft (7-124) to the groove (C) of the hold ring (7-79) in the posture
shown in the figure, apply the gear (7-54) to the gear shaft, insert the shaft head into
the hole (B) of the holder (7-51), apply the washer (7-52), and secure it with the E*clip
(7-53).
1-5
Installing the focusing ring (I) (7-63) and index ring assembly (7-24)
a.
Set the helicoid to its infinite position, fit the focusing ring with the 00 mark faced
upward, and install the screw (7-64) (b) . Next install the focusing ring with three set
screws (7-65) temporarily, set it in the position where the stopper stops at the infinite
and close-up distance.
NOTE:
Head of the set screw (7-65) must come into contact with the slope on the ring
(7-78). See Fig. D.
b.
Install the index ring assembly (7-24) with three screws (746), make sure that the
moquette (7-208) is not damaged and installed on the index ring correctly, and then,
screw the focusing ring (II) (7-61) into the focusing ring (I) (7-63).
c.
Fit the hood (7-203) to the protector ring (7-201), and with the index window (7-202)
faced upward, install them with two screws (7-207) together with the stopper ring
(7-206)
Make sure that the hood comes in and out smoothly.
Advertisement
Table of Contents
