Table of Contents
Advertisement
REASSEMBLY AND ADJUSTMENT
FUJI GW690-111 (PROFESSIONAL) /FUJI GSW690-III (PROFESSIONAL)
1-6 Installing the aperture selector ring (7-26)
a.
Fit the steel ball (7-35) to the index ring (7-28), apply grease (FHA-100) to the steel
ball and surroundings (sliding portion against the aperture selector ring), apply grease
to the click (j) portion of the apeture selector ring (7-26) slightly, fit the aperture
selector ring to the index ring, install two knobs (7-14) on the apeture selector ring
with two screws (7-15), turn the aperture selector ring, and make sure that it turns
smoothly and it clicks at each aperture effectively.
b.
Install the screw (7-27) on the aperture selector ring through the long groove (b) of the
index ring. Pass through the lead wires (7-216 and 7-217) through the hole, and hold
the lead wire ends on the PCB (7-30).
1-7
Installing the shutter
a.
With the shutter set lever set, fit two positioning pins on the back of the shutter to the
shutter positioning groove (E) of the shutter frame (7-48), and after checking the posi¬
tion, tighten it with the hold ring (7-125).
NOTE:
Be careful not to hold the lead wires between the parts.
Insert the screw (7-27) into the groove of the aperture lver (7-20), and make sure that
the screw head is projected 0.5 to 1mm.
b.
Turn the gear shaft (7-124), and make sure that the shutter can be charged and released
respectively when the gear shaft is turned to the right and left.
When adjustments of shutter charge and release are required, properly open or close
of the set plate (7-42). The adjustment procedure will be described later.
-
22
-
Advertisement
Table of Contents
