Introduction; Warranty And Product Liability - Danfoss Termix VVX-I-R FI - 7 Series Operating Manual

Termix VVX-I-R FI - 7 Series DS fully insulated

Introduction

This heat interface unit is intended for connecting to a heat network
for the production of both domestic hot water and space heating.
Read through the instructions before starting installation work.
Pay particular attention to the safety precautions.
The manufacturer assumes no responsibility for failure to follow the
instructions. This applies to both personal injury and product damage.
The following operating conditions must be carried out in accordance
with the directions below:
Assembly, installation and commissioning
General assembly, installation and commissioning must be
carried out by a qualified and authorised HVAC technician.
All electrical connections must be carried out by an authorised
electrician.
Daily operations
After correct installation and commissioning, under
normal circumstances further adjustment of the unit
will not be necessary.
Maintenance and cleaning
Regular maintenance of the heat interface unit is shown
in the section "maintenance". This section also describes
the cleaning procedures.
Dismantling
Dismantling the heat interface unit must be carried
out by an authorised and qualified HVAC technician.
For further information regarding disposal,
please refer to the section "disposal".

Warranty and product liability

Danfoss A/S' area of responsibility does not include balancing,
scope of works or mounting and correct connection of the unit.
If changes are carried out to the heat interface unit's configuration
or structure, the manufacturer can assume no responsibility.
The warranty does not cover incorrect use of the product.
LGB40450 © Danfoss | 2021.06| 3