Fitting Of Energy Meter - Danfoss Termix VVX-I-R FI - 7 Series Operating Manual

Termix VVX-I-R FI - 7 Series DS fully insulated

Fitting of energy meter

Fitting piece
The heat interface unit is equipped with a fitting piece for the energy
meter.
Mounting the energy meters:
• Close isolation valves
Close the isolation valves on DH Supply and DH Return, if there is water
in the system.
• Loosen nuts
Loosen the nuts on the fitting piece.
• Remove fitting piece
Remove the fitting piece and replace it with the energy meter. Don´t
forget the gaskets.
• Tighten connections
After mounting of the energy meter, remember to check and tighten all
threaded connections.
Sensor pocket
The sensors of the energy meter is mounted in the sensor pockets.
LGB40450
41
see diagram
14
see diagram
© Danfoss | 2021.06| 17