Electrical Connections And Wiring - Danfoss Termix VVX-I-R FI - 7 Series Operating Manual

Termix VVX-I-R FI - 7 Series DS fully insulated

Electrical connections and wiring

Before connecting the unit to an electrical supply, please note the
following:
Safety notes
Please read the relevant parts of the safety notes.
230 V
The heat interface unit must be connected to 230 V AC and earth.
Potential bonding
Potential bonding should be carried out according
to DS/HD 60364-4-41:2007 and IEC 60364-5-54:2011.
The bonding point is located on the bottom of the mounting plate in the
right corner and marked with an earth symbol.
Disconnection
The electrically connected heat interface unit must be disconnected for
repairs.
LGB40450
Authorised personnel
All electrical installation work may only be carried out by an
authorised electrician.
The electrical connection must be carried out in accordance
with applicable legislation and local standards.
It must be ensured that wires and cables do not come into contact
with the hot pipes. It must also be ensured that wires and cables
are not placed against sharp edges.
© Danfoss | 2021.06| 15