Troubleshooting - DeLonghi KS49 755.10 Manual

lIGhT
lAmPEGGIANTE

TROUBlEShOOTING

Below is a list of some of the possible malfunctions�
If the problem cannot be resolved as described, contact Customer Services�
PROBlEm
The coffee is not hot
The coffee is thin or not
creamy enough�
The coffee is delivered too
slowly or a drop at a time
Coffee does not come out of
one of the spouts
The frothed milk has large
bubbles
The milk is not frothed
Steam delivery stops during
use
The appliance does not
come on
POSSIBlE CAUSE
The infuser has not been replaced after
cleaning�
The inside of the appliance is very dirty�
POSSIBlE CAUSE
The cups were not preheated�
The infuser has cooled down because 2/3 minutes have
elapsed since the last coffee was made�
The coffee is ground too coarsely�
The coffee is unsuitable�
The coffee is ground too finely�
The spouts are blocked�
The milk is not cold enough or is not semi-skimmed�
Cappuccino maker dirty�
A safety device stops steam delivery after 3 minutes�
It is not plugged into the mains socket�
The main switch (A8) is not turned on�
REmEDY
Insert the infuser as described in the section "Cleaning
the infuser"�
Clean the inside of the appliance thoroughly, as described
in the section "Cleaning and maintenance"�
If the message is still displayed after cleaning, contact a
customer services�
REmEDY
Warm the cups by rinsing them with hot water (Please note
you can use the hot water or rinse function)�
Before making the coffee, warm the infuser by pressing the
rinse button
Turn the grinding adjustment dial one click anticlockwise
while the coffee mill is in operation (fig� 8)�
Continue one click at a time until coffee delivery is
satisfactory� The effect is only visible after delivering two
coffees (see the section: "Adjusting the coffee mill" on
page 13)�
Use pre-ground coffee for espresso coffee makers�
Turn the grinding adjustment dial one click clockwise while
the coffee mill is in operation (fig� 10)� Continue one click at
a time until coffee delivery is satisfactory� The effect is only
visible after delivering 2 coffees (see the section: "Adjusting
the coffee mill" on page 13)�
Clean the spouts with a toothpick�
You should ideally use skimmed or semi-skimmed milk at
refrigerator temperature (about 5°C)�
If the result is still disappointing, try another brand of milk�
Clean as described in the section "Cleaning the cappuccino
maker after use" on page 13�
Wait a few minutes, then activate the steam function
again�
Plug into the mains socket�
Place the main switch in the I position (fig� 1)�
18
�