Table of Contents
Advertisement
About this task
To install or replace the top cover on the 5U expansion enclosure, complete the following steps.
Procedure
1. Carefully lower the cover and ensure that it is aligned correctly with the back of the enclosure, as
shown in Figure 38 on page 38.
Figure 38. Aligning the top cover
2. Push the cover release lever to the side (
3. Slide the cover towards the back of the enclosure (
page 38.
Figure 39. Replacing the top cover
4. Verify that the cover correctly engages the cover release latch and all of the inset tabs on the
expansion enclosure.
5. Lock the cover into position by sliding the release lever
Figure 40. Locking the top cover
Installing a 5U expansion enclosure in a rack
Use the following procedure to place a 5U expansion enclosure in a rack during the installation process.
To complete some service tasks, you might also need to slide the enclosure back in to the rack.
About this task
Important: The 5U expansion enclosure is heavy. Before you install the expansion enclosure in the rack
for the first time or replace it in the rack to complete a service task, review and implement the following
tasks:
38 Storwize V5100 : Quick Installation Guide for MTM 2078-424, 2078-12F, 2078-24F, 2078-92F, and 2078-
U5B
2
) as shown in Figure 39 on page 38.
3
) back until it stops, as shown in Figure 39 on
4
, as shown in Figure 40 on page 38
Advertisement
Table of Contents
