Sony Digital8 DCR-TRV130 Operating Instructions Manual page 53

Using the built-in light
Notes
• The built-in light turns off automatically in the following cases:
-When it stays on in the AUTO nrode for more than 5 minutes
When you leave it on for more than 5 minutes with no cassette inserted or after the
tape has run out.
To turn the built-in light on again. Press LIGHT again.
• The battery pack is quickly discharging while the built-in light is turned on. Turn it off
when not in use.
• When you do not use vour camcorder, turn the built-in light off and remove the
battery pack to avoid iurning on the built-in light accidentally.
• When flickering occurs while shooting in the AUTO mode, press LIGHT until the
_l_li_l indicator appears.
• The built-in light may turn on/off when you use the PROGRAM AE or backlight
function while shooting in the AUTO mode.
• The built-in light may be turned off when inserting or _,jecting a cassette.
•While the end search function is working, the built-in light is turned off.
• When you use the conversion lens (optional), light from the built-in light is blocked
and may not illuminate the subject properly.
Use the Sony XB-3D halogen lanrp (optional). The supplied halogen lamp is not on the
nrarket. Purchase the Sony XB-3D halogen lamp.
Remove the power source before replacing the bulb.
(1) Remove the built-in light unit while pushing the hole under the built-in light
unit using a wire.
(2) Turn the bulb housing counterclockwise and detach from the built-in light
unit.
('t) Replace the bulb using a dry cloth.
(4) Attach the bulb housing turning it clockwise, then replace the built-in light
unit.
Q,.
=<
8_
O
K
o
2 3
53