Advertisement
OIL PUMP
e Before mounting the oil pump, apply engine oil
to the sliding surfaces of the case, outer rotor,
inner rotor and shaft.
e Apply
a small
quantity
of THREAD
LOCK
"1342" to the oil pump mounting screws.
99000-32050
Thread lock ''1342"
@ Tighten the oil pump mounting screws.
09900-09003
Impact driver set
NOTE:
After
installing
the oil pump
driven
gear,
rotate the pump gear by hand to see if it turns
smoothly.
CAM
DRIVE SPORCKET
e@ Install
the cam
drive sprocket onto
the crank-
shaft, then fit the key ( in the key slot on the
crankshaft.
@ Engage the cam drive chain onto the cam drive
sprocket.
Cin.
ebheva»
OREO
29 466
PRIMARY
DRIVE GEAR
e
Fit the key (@ in the key slot on the crankshaft,
then
install the primary drive gear, washer and
nut.
| 09910-20116
|
Conrod holder
P|
Advertisement
