Kenwood TH-77A Instruction Manual page 43

For example,
with each other.
the following groups communicate
Predetermined frequency 145.660MHz
Group code 789
Member 1 Individual Code 111
Member 2 Individual Code 222
Member 3 Individual Code 333
Member 4 Individual Code 444
Member 1 Member 2 Member 4
A 111 A 222 A 444
0 2 789 4 789
1 0 0
2
3 789
4 444 &
5 Member 3
A 333
3 789
0
4-9-3. Paging Transmission (Calling)
Your station ID code is preset in memory A. (The local
station ID code is always stored in memory A.)
1. Tune to the predetermined frequency.
2. Press the F key, then press the 6/M.DT key (5/S.DT key
for a subband) to enter the paging mode.
The paging function of the other transceiver must be
ON, too.
3. Press the SCAN key (F key, then SCAN key for a
subband) to enter the code setting mode.
4. Use the tuning control to select the memory channel
in which the local station code is stored.( A V keys
B APO
The PAGING code may not be accepted if the repeater is "identifying".
If this should occur you should press the PTT switch again, and
retransmit the PAGING code.
43