Kenwood TH-77A Instruction Manual page 24

©O:Can be stored in memory, NA : Cannot be stored in
memory.)
channel Normal Split
channel channel
RX frequency (S, oO
TX frequency NA oe
Tone(CTCSS) frequenc
na ee tals, O ©
Frequency step a '©
Shift status REV status oe NA
%* _DTSS code DTSS status ie) oe)
(«) When the TX frequency is entered in the memory,
the shift state and reverse on/off set for the receive
frequency are deleted from the memory.
4-4-5. Memory Entry
@Normal Channel Entry
or Odd Split Channel RX Frequency Entry
1. Using the ENT key and numeric keys select the
desired receiver frequency, tone information etc.
2. Press the M key momentarily. The memory channel
indicator will flash.
24
oe wna mh 670
Se ovkh. O40
APO
3. Select any memory channel (00 ~ 39) using the nu-
meric keys.To enter data in memory a 2-digit number
is used .
iy example CH 5 is channel 05,and CH 15 is channel
Memory channel number will turn off. This indicates
that the receiver data has been properly stored in
memory.
@ IX frequency entry (Split channel only)
NOTE
When the RX frequency is rewritten in the odd split
channel the TX frequency of the channel is
automatically erased.
2. Press the M key momentarily. The memory channel
indicator will flash.