Turning Your Phone On And Off; Using Your Phone's Battery And Charger - UTStarcom CDM7000 User Manual

Turning Your Phone On and Off

To turn your phone on:
Press and hold
Once your phone is on, it may display "Searching for
Service," which indicates that your phone is searching for
a signal. When your phone finds a signal, it automatically
enters standby mode – the phone's idle state. At this
point, you are ready to begin making and receiving calls.
If your phone is unable to find a signal after 15 minutes of
searching, a Power Save feature is automatically
activated. When a signal is found, your phone
automatically returns to standby mode.
In Power Save mode, your phone searches for a signal
periodically without your intervention. You can also initiate
a search for service by pressing any key (when your
phone is turned on).
Tip:
The Power Save feature helps to conserve your battery power
when you are in an area where there is no signal.
To turn your phone off:
Press and hold
the powering down animation on the display screen.
Your screen remains blank while your phone is off (unless
the battery is charging).
Using Your Phone's Battery and
Charger
Battery Capacity
Your phone is equipped with a Lithium Ion (LiIon) battery.
It allows you to recharge your battery before it is fully
12
for approximately two seconds.
for two seconds until you see