Pendser Wie Inercdtntunane Nes - Pioneer SX-2900 Operating Instructions Manual

PRESET TUNING
FREQUENCY PRESETTING
Allows three stations per STATION CALL button (press once, twice,
or three times to select).
123 4
3,5 3
1. Press the POWER switch to the ON position.
NOTE:
Be sure to turn the TAPE 2 MONITOR button OFF when listening to
AM or FM broadcasts.
2. Set the BAND selector to either FM or AM.
3. Tune in the desired station.
® See the section ''DIRECT ACCESS TUNING" for information on
reception using the Direct Access Tuning mode.
¢ See the section 'AUTO TUNING" for information on reception
using the Auto Tuning mode.
e See the section 'MANUAL TUNING" for information on reception
using the Manual Tuning mode.
In addition to station frequencies, the FM MODE (AUTO/MONO)
can also be preset.
4. Press the MEMORY button.
5. Press the STATION CALL button into which you wish
to preset the station.
® Press the STATION CALL button while the MEMORY indicator
is flashing (about 5 seconds).
e Use the STATION CALL buttons (* 1 — *9, *O) to select a preset
channel. One press selects the 1 — 10 range, two presses 11 —
20, and three presses 21 — 30.
[Example] If you press button [*3 | :
Once — STATION 3
Twice — STATION 13
Three times — STATION 23
Press a STATION CALL button within two seconds.
When the display stops flashing, the station is preset.
NOTE:
Do not press buttons while the display is still flashing.
6. Repeat steps 2 to 5 to preset additional stations.
A total of 30 AM and FM stations may be preset. When you store
a new preset, it takes the place of the previously stored station (if
any).
12
<ARB1286>
LISTENING TO BROADCASTS USING PRESET
TUNING
1. Press the POWER switch to the ON position.
2. Press the STATION CALL button into which the
desired station has been preset.
¢ When the Function button is set to a function other than TUNER,
it will switch to the TUNER function automatically if one of the
STATION CALL buttons is pressed.
Tuning can be performed simply and accurately following the
above procedure.
3. Adjust the volume with the VOLUME control and the
tone with the GRAPHIC EQUALIZER controls.
NOTE:
The contents of the STATION CALL button will be preserved for several
days, even if the receiver power cord is unplugged.
lf a preset station has been erased, preset it again.
Last station memory
The last received AM and FM stations remain stored despite FUNCTION
and/or POWER switching. To recall, use BAND selector buttons.
HOW TO USE THE CUSTOM MEMORY
Preset stations can be classified into as many as three different genres
according to the material played by the station. Each of these three
genres can be given a name, and Memory Scan of all the stations of
a particular genre can be carried out.
The initial STATION CALL numbers are classified and named as follows.
STATION CALL NO. NAME
It is recommended that you assign station call switches to appropriate
stations to be preset.