Listening To The Broadcast - Pioneer SX-2900 Operating Instructions Manual

LISTENING TO THE BROADCAST
¢ Check that all terminals are properly connected before switching on
the unit.
¢ Be sure to turn the TAPE 2 MONITOR button OFF when listening to
AM or FM broadcasts.
AUTO TUNING (FM reception)
The electronic tuning circuit inside the unit will search for the station.
. Press the POWER switch to the ON position.
. Press the TUNER button of the function buttons.
. Set the BAND selector buttons for FM reception.
. Press the FM TUNING AUTO/MANUAL button to
establish the AUTO tuning mode (the AUTO indicator
lights).
5. Press the TUNING buttons "UP +" or "DOWN -"' for
a higher or lower frequency as desired.
The frequency will change rapidly during scanning. The AUTO
TUNING will stop automatically when the station is located and the
TUNED indicator will light up.
NOTE:
When the AUTO TUNING is in use, reception may not be possible over
long distances or when signals are weak. At these times manual tuning
is recommended.
hWN =
6. Adjust the volume with the VOLUME control and the
tone with the GRAPHIC EQUALIZER controls.
10
<ARB1286>
MANUAL TUNING (FM/AM reception)
1 6
3 5 24
1. Press the POWER switch to the ON position.
2. Press the TUNER button of the function buttons.
3. Select your desired broadcasting band using the
BAND selector buttons.
4.Press the FM TUNING AUTO/MANUAL button to
establish the MANUAL tuning mode (the AUTO
indicator goes off) during FM reception.
5. Use the TUNING buttons to locate the frequency of
the desired station.
For step-by-step searching, press the TUNING button once and
release it immediately. For continuous rapid scanning keep the
TUNING button pressed. The TUNED indicator will light up when
the station is tuned in best.
NOTE:
The TUNED indicator will not function for broadcasts received over long
distances or when signals are weak.
6. Adjust the volume with the VOLUME control and the
tone with the GRAPHIC EQUALIZER controls.