For 3" - 6" piping
Use paddle b = 29 mm
Refrigerating circuit safety valves
Each system comes with safety valves that are installed on each circuit, both on the evaporator and on the condenser.
The purpose of the valves is to release the refrigerant inside the refrigerant circuit in the event of certain malfunctions.
The unit is designed for indoor installation.
Damage may be caused by inhaling the refrigerant gas. Avoid the release of the refrigerant into the atmosphere.
The safety valves must be connected to the outdoor environment. The installer is responsible for connecting the
safety valves to the drainage pipes and for their correct dimensioning.
Check for adequate air circulation around the machine.
General specifications
All electrical connections to the machine must be carried out in compliance with applicable laws and regulations.
All installation, operating and maintenance activities must be carried out by qualified personnel.
Please refer to the specific wiring diagram for the machine that you have purchased and which was sent with the unit.
Should the wiring diagram not appear on the machine or should it have been lost, please contact your dealer who will
provide for a copy to be forwarded.
D–EIMWC00408-16EN - 14/60
All manuals and user guides at all-guides.com
3"
83 mm
4"
107 mm
5"
134 mm
6"
162 mm
5 mm
Fig. 5 - Adjusting the safety flow switch
WARNING
CAUTION
Adjusting
the
flow
switch's
trigger sensitivity