Advertisement
Playback your Recordings
Playback or View on a TV
Your Palmcorder may be connected to a
TV to play back tapes or to view what you
are recording.
TV with AUDIO/VIDEO IN Jacks.
ja of T
To Audio In | |
Audio/Video
Cable
(Supplied)
Y
To Audio/Video Out
TV without AUDIO/VIDEO IN Jacks.
pro
—
=
To Audio
Video Out
p^ :
RF Adaptor
(optional)
VHF Antenna
300 ohm-75 ohm
transtormer
(not supplied)
or F Connector
UHF Antenna
Selector
VHF Connecting
Cable
(not supplied)
To VHF Antenna
Terminal
26
Before you begin...
* Connect the Palmcorder to a power source.
1 Set the POWER switch to VCR to
playback a tape.
Or, set to CAMERA to view what your
Palmcorder is recording.
22 sim the TV ON and set it to LINE
INPUT.
Check your TV operating instructions
for further information.
Note:
If your TV has no VIDEO or AUDIO IN
Jacks, select CH 3 or 4 on your TV to match
the RF Adaptor CH 3/4 switch and set the
VCR/TV selector on the RF Adaptor to VCR.
3 Start playback or begin a recording.
To watch TV only
If you have connected the Palmcorder
to your TV using an RF Adaptor:
Set the POWER switch to OFF on the
Palmcorder.
Then, set the VCR/TV Selector on
the RF Adaptor to TV.
Now, turn the TV ON and select a
channel.
CATV System Installer
This reminder is provided to call the
CATV system installer's attention to
Article 820-40 of the NEC in USA (and
to the Canadian Electrical code in
Canada) that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
Advertisement
