Advertisement
Programmed Recording
Programmed Recording
Before you begin...
You can program when to start and stop
* Connect the Palmcorder to a power source.
the recording just like the Stand-by OTR
For extended periods of recording, it is
on a VCR deck. This is very convenient
recommended to use the AC Adaptor for a
n i
d i e
power source.
when you record something like a
* Insert a cassette with record tab (see page 10).
blooming flower while you are out. You
* Set the POWER switch to CAMERA.
can also use an interval recording. Two
recording lengths, 5-second per minute or
10-second per minute, are available.
1
es
Aim the Remote Control at the Remote
Sensor and press STANDBY on the
Remote repeatedly until the desired
time to start will appear.
Start time will increase 30 minutes.
Remote
Sensor
UJ
to
n
©)
O
Lo)
(D
m.
t
=.
o
-
Press OTR on the Remote repeatedly
to select desired recording length.
10MIN. — 20MIN. — 30MIN. —TO TAPE END
|
INTERVAL?
INTERVAL!
|
10 SEC/MIN.
~
5 SEC/MIN.
"1 5-second recording will be made
each minute.
*2 10-second recording will be made
each minute.
PAUSE
O
J After setting, press REC/PAUSE on
the Remote to go into stand-by mode.
STAND-BY
START; 10:30PM
REC TIME: 30MIN.
10:20:00PM
JUN
11996
Note:
The Palmcorder will start recording at
* Palmcorder will automatically turn off
the desired timing. When the recording
after 12 hours from recording start time or
finishes, the Palmcorder will turn off
at tape end.
automatically.
* Set the POWER switch to OFF to cancel
the Programmed Recording feature.
23
Advertisement
