Advertisement
Camera Recording
Stand-by Mode
Whenever the Palmcorder has been in Record/Pause mode for 5 minutes, it will auto-
matically go into Stand-by mode to conserve power. To resume recording, it is necessary
to turn the Palmcorder POWER switch to OFF and then to CAMERA. Or, you may use
the following feature to avoid having to turn the Palmcorder off and on again.
Stand-by Release
EE yeu begin.
:
;
* Connect the Palmcorder to a power source.
ane feature allows you to eeu
record
* Insert a cassette with record tab (see page 10).
ing from Stand-by mode by simply pressing
the RECORD/PAUSE button.
1 While pressing the UP A button, set
the POWER switch to CAMERA.
2 Press UP A more than 2 seconds to
display the STAND-BY
RELEASE
selection screen.
STAND-BY
RELEASE
BY RECORU/PAUSE
KEY
ACTIVE
NON-ACTIVE
SELECT: PUSH
V/A KEY
SET
: PUSH DISPLAY KEY
J Press UP A or DOWN Y as
necessary to select aiid.
A bres: DISPLAY to set your selection
and exit this screen.
. You may now turn the Palmcorder
back on after it has gone into Stand-
RECORD/PAUSE
by mode by pressing the RECORD/
PAUSE button.
Note:
If
was selected in step 3
above, you must set the POWER switch to
OFF and then to CAMERA to resume
recording from Stand-by mode.
20
Advertisement
