Setting Lockout On A Car; Programming Conventional Systems - Uniden SC230 Owner's Manual

SC230 Paper OM.fm Page 52 Wednesday, October 6, 2004 10:51 AM

Setting Lockout On A Car

Program SysteM
Menu
Select the system
E
Edit Car
Select the car E
E
Set Lockout
This setting determines whether the scanner will scan this
car when it is enabled. Select your setting, then press E.
Lockout - the car is not scanned.
Unlocked - the car is scanned.
Note: The default setting is Unlocked.

Programming Conventional Systems

Program SysteM
Menu
E
New System
E E
Confirm?
The scanner creates an empty conventional system, with
a default name of System nnn
as you add new systems. C indicates that this is a
conventional system.
Refer to the appropriate section to set system-wide options:
• See "Editing the System Name" on Page 55
• See "Editing the System Quick Key (Conventional
Systems Only)" on Page 55
• See "Setting System Lockout" on Page 56
• See "Setting the System Hold Time" on Page 56
• See "Setting the Channel Delay Time" on Page 57
• See "Setting Data Skip" on Page 57
• See "Deleting Systems" on Page 58
• See "Copying Systems" on Page 58
• See "Entering/Editing Conventional Channel Groups"
on Page 53
Programming Radio Systems
E
E
E
Conventional
C. nnn increments
52