Using The Close Call Feature - Uniden SC230 Owner's Manual

SC230 Paper OM.fm Page 72 Wednesday, October 6, 2004 10:51 AM

Using the Close Call Feature

Using the Close Call Feature
Your scanner's Close Call
scanner so it detects, displays the frequency of, and lets
you hear a nearby strong radio transmission. You can set
the scanner so the Close Call feature works "in the
background" while you are scanning other frequencies,
turn off normal scanning while the Close Call feature is
working, or turn off the Close Call feature and use the
scanner normally. You can set the scanner so it alerts you
when the Close Call feature finds a frequency. You can
also set the frequency band where you want the scanner
to look for transmissions.
To turn Close Call detection on or off, press
. When the feature is on,
and normal operation is briefly interrupted about every 2
seconds.
Notes:
• The Close Call feature works well for locating the
source of strong local transmissions such as mobile
and handheld two-way radios in areas with no other
strong transmission sources. Several factors affect
Close Call performance, however. Performance is
increased with higher transmit power, receive
antenna tuned to the target band, and a low
background RF level. Other than the antenna, you
have no control over these factors, but they explain
why performance might vary by both location and time.
• The Close Call feature cannot detect satellite dishes
or any transmitter with a frequency above or below
the frequency ranges listed under "Setting Close Call
Options" on Page 73.
• The Close Call feature works better with some types
of transmissions than others. It might not correctly
display frequency information for transmitters using a
highly directional antenna (such as an amateur radio
beam antenna) or if there are many transmitters
operating at the same time in the same area.
Using the Close Call Feature
TM feature lets you set the
Func
appears on the display
72
then