Using The Backlight; Initializing The Scanner's Memory - Uniden SC230 Owner's Manual

SC230 Paper OM.fm Page 41 Wednesday, October 6, 2004 10:51 AM
• Priority Off: Normal scanning
• Priority On: While scanning, the scanner interrupts
every 2 seconds and checks the priority channels in
each unlocked system. Priority channels in lower
priority key numbered systems (starting from 1) have
highest priority. Pri appears when you select this
mode.
• Priority Plus: The scanner only scans priority
channels in unlocked systems. Pri flashes when you
select this mode.
Other Settings

Using the Backlight

Set Backlight
Menu
• 10 sec The backlight stays on for 10 seconds after
you press +
Func
• 30 sec The backlight stays on for 30 seconds after
you press +
Func
• Squelch The backlight turns on when the squelch
opens then stays on for 5 seconds.
• Keypress The backlight turns on when any key is
pressed then stays on for 10 seconds.
• Infinite The backlight turns on when you press
+ then stays on until you press
Pressing any key while the backlight is on extends the
backlight period. Pressing
is on turns off the backlight.

Initializing the Scanner's Memory

Important! This deletes all preprogrammed data.
You cannot restore preprogrammed data that has
been deleted.
To initialize the scanner's memory, turn off the scanner.
Then, press 2, 9, and Hold while turning it on.
E
.
.
+
Func
while the backlight
+
Func
Other Settings
41
Func
again.