Table of Contents
Advertisement
3 – CLEANING
Cleaning after Daily use
Clean the drip tray after each use.
!
Note: The drip tray (I) can be washed with hot water and a mild
detergent (17) and must not be washed in the dishwasher.
!
Warning! Never use harsh detergents, such as vinegar, acids, solvents
or petrol.
Cleaning during Installation of a new Torp
Clean away all traces of beer that have built up on the tap.
The tap mechanism should be cleaned with a damp cloth and some mild
detergent (18).
Remove the empty TORP from the refrigeration chamber by pressing on
the front part to remove the rear part (19).
!
Warning! Do not attempt to clean the mechanism with hard and/or
sharp objects.
Clean the cooling chamber of THE SUB COMPACT using a soft dry cloth
(20).
Problem
THE SUB COMPACT does
THE SUB COMPACT is not
not turn on.
connected to the mains
power supply.
The electronic board may be
defective.
The upper part of the
The upper part of the head
dispensing head does not fit
is not correctly inserted.
correctly.
You can not close the door
THE TORP is not inserted
of THE SUB COMPACT.
completely.
14
Troubleshooting
Possible causes
Remedies
Connect THE SUB COMPACT
to the power supply.
Contact the KRUPS customer
service.
Remove the tube spout from
THE SUB COMPACT and fit
it again following chapter
«Installing THE TORP in THE
SUB COMPACT»
Insert THE TORP in THE SUB
COMPACT completely.
Troubleshooting
Problem
Possible causes
No beer is being dispensed.
THE SUB COMPACT has
been switched off.
THE TORP is empty.
There is no TORP inside THE
SUB COMPACT.
THE SUB COMPACT tap
handle is not correctly
installed/positioned.
There is not enough pressure
in THE TORP.
THE SUB COMPACT is
THE SUB COMPACT is not
dispensing warm beer.
connected to the mains
power supply.
The door was not closed
correctly.
The cooling system is
defective.
There is ice in the cooling
The room temperature is
chamber.
below 12°C.
THE SUB COMPACT has
been working too long with
no TORP inside.
The temperature regulation
may be defective.
EN
Remedies
Connect the appliance to
the power supply.
Replace THE TORP with a
new one.
Install a TORP inside THE
SUB COMPACT.
Install/position the tap
correctly.
Open the door, remove THE
TORP and press THE TORP
detector at the front of the
refrigeration chamber.
1 If the pump is working: it
means there is a problem
with THE TORP. Install
a new TORP in THE SUB
COMPACT.
2 If the pump is not working:
it may be defective.
Contact the KRUPS
customer service.
Connect THE SUB COMPACT
to the power supply.
Close the door correctly.
Contact the KRUPS customer
service.
Install THE SUB COMPACT
in an adapted environment.
Remove the ice with a warm
sponge and load a TORP
inside the chamber.
Contact the KRUPS customer
service.
15
Advertisement
Table of Contents
