Table of Contents
Advertisement
1.4
PACKAGE CONTENTS
ORB 2.2GB USB drive, power supply, SCSI (HD50) to
USB adapter cable, ORB Installation Suite CD and
ORB Quick Installation Guide.
Emergency eject hole
Disk insert/eject button
Figure 2
Front View
1.5
INSTALLATION PRECAUTIONS
Be sure to read the following Installation Safety Instructions before moving on
to the actual installation steps. Damage may occur to the drive and disk if these
precautions are not followed. If for any reason you do not understand these
instructions, please contact a qualified computer technician to install or assist
in the installation.
Temperature Stabilization - Before removing the drive from its protective
plastic bag, ensure the drive has reached room temperature. This is
accomplished by allowing the drive to sit in its protective plastic bag in the
room environment for at least one hour.
Shock - Dropping, jarring, or moving the drive while the disk is spinning can
cause catastrophic damage. The drive should be placed on a flat, horizontal
surface whenever an ORB disk is installed. The ORB disk should always be
removed from the drive before the ORB drive is moved.
Power - Always attach cable(s) to the drive then the power supply. Then
the USB connector can be attached to/detached from your computer system
with drive power either on or off.
Magnetic Interference - Do not place the drive and/or disk near a monitor
or speaker as interference from such a device may affect the normal operation
of the drive.
Become familiar with your ORB drive
Power/Status LED
4
SCSI IN
POWER
SCSI OUT
SCSI IN
Power supply connector
Figure 3
Rear View
E
USB
XTERNAL
QUICK
INSTALLATION
GUIDE
The simple, easy, short-cut
to get you up and running
with your new ORB drive.
Figure 1
SCSI OUT
Advertisement
Table of Contents
