Installation - Ultratec CrystalTone Plus User Manual

INSTALLATION

To set up the CrystalTone Plus, all you do is
insert a backup battery, connect the telephone
line, then plug it in! You can also choose to
mount the phone on the wall.
CrystalTone Plus includes the following parts:
✔
CrystalTone Plus amplified phone
✔
Handset with coiled cord
✔
AC adapter
✔
7-foot telephone line cord
✔
6-inch telephone line cord (for use when
mounting on wall)
✔
Desktop/wall adapter
CAUTION! Do not plug the CrystalTone
Plus into any telephone line other than a
standard, analog telephone line. Connection
to a digital system may damage the
CrystalTone Plus or the telephone system and
will void your warranty.
1. SELECTING A LOCATION
The CrystalTone Plus requires a standard
(analog) telephone line with either pulse or
tone (also called touchtone) dialing. To use
the CrystalTone Plus with a digital system,
some modifications to the telephone line are
required.
Set up the CrystalTone Plus in a place where:
✔
There is an electrical outlet nearby.
✔
There is a phone jack nearby.
✔
The Ring Flasher is easily visible.
✔
The surface it is set on, or mounted to, is
stable and secure.
✔
The area is protected from excessive heat or
humidity.
2. INSTALLING THE BACKUP BATTERY
Installing a battery allows you to use the
CrystalTone Plus continuously for one hour
during a power failure. The battery does not
■
4 INSTALLATION
save Speed-Dial numbers. Speed-Dial memory
is powered by the telephone line.
CAUTION! Disconnect the telephone line
and the power adapter before opening the
battery compartment.
Use a 9V alkaline battery. The battery
compartment is on the bottom of the
CrystalTone Plus.
1. Unplug both the telephone line and the
power adapter, if attached.
2. If it is connected,
remove the desk-
top/wall adapter.
(This will be re-
placed after setup
is complete.)
3. Use something
small like the tip of
a pencil to push in
the release on the
battery cover. The
release is marked
by the symbol.
4. Hold down the
release and slide
the cover toward
the outer edge of
the phone. Then,
pull up the cover.
5. Snap the battery
connector onto the
battery.
6. Place the battery
into the compart-
ment making sure
that the connector
and wire are completely inside the
compartment and will not be pinched
when the cover is replaced.
7. Replace the battery cover, making sure it
snaps securely into place.
Slide
Hold down