Pole Mounting The Gnss Antenna - Cisco Catalyst Wireless 9163E Manual

Pole Mounting the GNSS Antenna

Before you begin
Ensure that you have the following materials before beginning to mount the GNSS antenna to a wall:
Table 11: Material Required to Mount CW-ANT-GPS2-S-00 to a Wall
Materials Required
Wall/pole mount bracket
Two wall mounting screws
Two wall anchors (specified for all material)
Drill bit for wall anchors
Electric drill and standard screwdriver
Procedure
Step 1
Use the GNSS CW-ANT-GPS2-S-00 mounting bracket as a template to mark the two screw hole locations
on the mounting wall.
Step 2
Use two screws and, if required, wall anchors to attach the mounting bracket to the mounting surface. These
screws and anchors are to be sourced independently.
Note
Step 3
Screw an M6 x12–mm screw into each of the two support bolt holes on the bracket.
Step 4 Remove the protective cap and connect the antenna to the GNSS port.
The GNSS port is located at the top of the AP. See
Pole Mounting the GNSS Antenna
The CW-ANT-GPS2-S-00 is a mounting bracket with the GNSS antenna for mounting the antenna to a wall
or a pole.
Cisco Catalyst Wireless 9163E Access Point Hardware Installation and Deployment Guide
36
You can use an exterior-grade plywood backboard to mount the GNSS antenna to stucco, cement,
or drywall.
Supplied in the
Kit?
Yes
No
No
No
No
Connectors and Ports on the AP, on page
Installing the Access Point
5.