Installing A Cat 6/6A Ethernet Cable And Gland Assembly To The Access Point - Cisco Catalyst Wireless 9163E Manual

Installing the Access Point

Installing a CAT 6/6A Ethernet Cable and Gland Assembly to the Access Point

Figure 14: CAT 6/6a Cable Gland Assembly
1
2
3
4
Before you begin
You must supply these tools and materials:
• Shielded outdoor-rated Ethernet (CAT 6 or CAT 6A) cable with a diameter of 0.2 to 0.35 inch (5 to 9
• CAT 6 RJ45 connector installation tool
• Adjustable wrench or 18–mm box wrench
• CAT 6 / CAT 6A gland ordered separately with AIR-ACC-CAT6= kit
CAT 6/6A RJ45 Plug
RJ45 wire load bar
Note the orientation into plug
Gasket
It is pre-attached to the Clamp ring.
Clamp ring
mm)
Cisco Catalyst Wireless 9163E Access Point Hardware Installation and Deployment Guide
Installing a CAT 6/6A Ethernet Cable and Gland Assembly to the Access Point
5 Screw nut
6 Cable Seal (Cable OD range 5 mm to 7
mm)
7 Cable Seal (Cable OD range 7 mm to9
mm)
8 Cable sealing nut
33