Mounting the Access Point
Using the long bolt and the hardware supplied with the pivoting bracket, bolt the AP and its mounted
Step 6
bracket, on to the bracket mounted on the wall (see
Step 7
Pivot the AP to your desired position, and then tighten the bolts (using a 13 mm wrench).
Continue with
Step 8
Pole Mounting the Access Point with the Pivoting Mounting Kit
The optional pivoting mounting kit contains a mounting bracket for wall mounting or pole mounting,
along with a clamp for pole mounting.This kit can be used to install the access point on a pole, mast or
streetlight. It supports metal, wood or fiberglass poles from 2 to 8 inches in diameter.
Figure 2-10
1
3
Cisco Aironet 1530 Series Outdoor Access Point Hardware Installation Guide
2-20
Grounding the Access Point, page
Pivoting Mounting Kit with Pole Mount Clamp
1
Mounting holes for the access point
Pole mount clamp. It can fit poles of range up
to 3 in. (76mm)
Chapter 2
Figure 2-11
for an exploded view of this assembly).
2-40.
2
Slots for band clamps (band clamps are
provided but not shown in this figure. See
Figure
2-12).
Installing the Access Point
2
3
OL-30864-01