Mounting The Access Point; Choosing A Mounting Kit - Cisco Catalyst 9124AX Series Hardware Installation Manual

Mounting the Access Point

Note
Mounting the Access Point
This section provides instructions to mount the AP. Personnel mounting the AP must have knowledge of the
wireless AP, bridging techniques, and grounding methods.

Choosing a Mounting Kit

You can mount the AP in one of the following configurations:
• On a vertical wall or pole
• On a horizontal eave or pole
• On a cable strand
AP Mounting Kit
AIR-MNT-VERT1=
AIR-MNT-VERT2=
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
24
When you are installing a Layer 3 AP on a different subnet than the controller, ensure the following:
• Ensure that a DHCP server is reachable from the subnet on which you want to install the AP.
• The subnet has a route back to the controller and ensure that the route back to the controller
has the destination UDP ports 5246 and 5247 open for CAPWAP communications.
• Ensure that the route back to the primary, secondary, and tertiary controllers allows IP packet
fragments.
• Ensure that the AP and the controller have a static 1-to-1 NAT to an outside address if address
translation is used. (Port Address Translation is not supported.).
3
9124AXI
N
N
9124AXD Purpose
Fixed mounting kit for vertical mounting on wall
and for pole of diameter 2 to 5 inch (51 to 127
mm). See:
Y
Vertically Mounting the AP to a Wall, on page
25
Vertically Mounting the AP to a Pole, on page 28
Fixed mounting kit, allowing mounting of both
AP and power supply, for vertical mounting on
wall and for pole of diameter 2 to 5 inch (51 to
127 mm). See:
Y
Vertically Mounting the AP with DC Supply to a
Wall, on page 30
Vertically Mounting the AP with DC Supply to a
Pole, on page 31
Installation Overview