Advertisement
5. OPERATING PROCEDURE
Keep the Manual/Auto mode switch in Auto mode for automatic operation.
Ÿ
Give power to the Controller, Power ON LED will glow.
Ÿ
When Over Head Tank (OHT) level goes low, controller turns ON the motor.
Ÿ
Then MOTOR ON LED will glow. This operation occurs only when water is
present at Under Ground Tank (UGT). SUMP LED will be ON in this condition.
When Over Head Tank (OHT) is full or when UGT level becomes empty (SUMP
Ÿ
LED in OFF condition), the controller turns OFF the motor and MOTOR ON
LED will be OFF.
In manual mode, Motor will be continuously running. MOTOR ON LED will be
Ÿ
ON.
6. TROUBLE SHOOTING METHODS
S.
Error
No.
1
Device dead
/ Not
Powered ON
2
Motor not
switching
ON
Solutions
a. Check the power connection wires for loose contacts.
b. If problem persists, contact RMG Automation for
support.
a. Check whether the connections are given properly.
b. If connections are okay and still issue persist, contact
RMG Automation for support.
3
Advertisement
