Advertisement
Installing the U.S. Robotics 56K PC Card Winmodem with
®
XJACK
Connector
Step One: Install the modem.
Turn off your computer. Insert the modem into the PC card slot in your computer.
The top of the modem has an arrow indicating which end should be inserted into
the computer. Make sure that the modem is firmly seated in the PC card slot.
Step Two: Connect the phone cord.
Push in on the XJACK connector to pop it out
of the PC card. Connect one end of a standard
RJ-11 phone cord to the XJACK connector and
the other end to an analog telephone wall
jack. Refer to this illustration:
Step Three: Install the drivers.
Note:
the location of your installation drivers, select the CD-ROM drive where
the Installation CD-ROM is loaded (D:\ for example). For Windows 2000
and XP users, also select the 2000_XP folder on the Installation CD-ROM
(D:\2000_XP for example).
Note:
with administrative privileges before attempting to install the modem
drivers. Windows XP Home Edition users have administrative privileges
by default.
Windows XP
Turn on your computer. When the Found New Hardware Wizard detects your
modem, insert the Installation CD-ROM into your CD-ROM drive. Windows
should automatically find the driver for your modem. (If not, select Install the
software automatically (recommended) and click Next.) If a Hardware
Installation message box appears, click Continue Anyway*. Click Finish to
complete the installation.
* U.S. Robotics has thoroughly tested this driver in conjunction with the supported hardware and has
verified compatibility with Windows XP.
4
If at any time during the installation you are prompted to select
Windows 2000 and XP users must be logged in using an account
Advertisement
