Advertisement
apparatus set out in the interference-causing equipment standard entitled Digital Apparatus, ICES-003
of Industry Canada.
NOTICE:
The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication
of the maximum number of terminals allowed to be connected to a telephone interface. The termination
on an interface may consist of any combination of devices subject only to the requirement that the sum
of the Ringer Equivalence Numbers of all devices does not exceed 5. The Ringer Equivalence Number is
located on the bottom of the modem.
NOTICE:
The Industry Canada (IC) label identifies certified equipment. This certification means the
equipment meets certain telecommunications network protective, operational, and safety
requirements as prescribed in the appropriate Terminal Equipment Technical Requirements
document(s). The Department does not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the
facilities of the local telecommunications company. The equipment must also be installed using an
acceptable method of connection. In some cases, the company's inside wiring associated with a single-
line, individual service may be extended by means of a certified connector assembly (telephone
extension cord). The customer should be aware that compliance with the above conditions may not
prevent degradation of service in some situations. Currently, telecommunication companies do not
allow users to connect their equipment to jacks except in precise situations that are spelled out in
tariffing arrangements with those companies. Repairs to certified equipment should be coordinated by
a representative designated by the supplier. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the telecommunications company cause to request
the user to disconnect the equipment.
«AVIS:
Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux appareils
numériques de classe B prescrites dans la norme sur le matériel brouilleur: "Appareils Numériques",
NMB-003 édictée par l'Industrie Canada.
L'étiquette d'Industrie Canada identifie le matériel homologué. Cette étiquette certifie que le matériel
est conforme aux normes de protection, d'exploitation et de sécurité des réseaux de
télécommunications, comme le prescrivent les documents concernant les exigences techniques
relatives au matériel terminal. Le Ministère n'assure toutefois pas que le matériel fonctionnera à la
satisfaction de l'utilisateur.
Avant d'installer ce matériel, l'utilisateur doit s'assurer qu'il est permis de le raccorder aux installations
de l'entreprise locale de télécommunication. Le matériel doit également être installé en suivant une
méthode acceptée de raccordement. L'abonné ne doit pas oublier qu'il est possible que la conformité
aux conditions énoncées cidessus n'empêche pas la dégradation du service dans certaines situations.
Les réparations de matériel homologué doivent être coordonnées par un représentant désigné par le
fournisseur. L'entreprise de télécommunications peut demander à l'utilisateur de débrancher un
appareil à la suite de réparations ou de modifications effectuées par l'utilisateur ou à cause de
mauvaisfonctionnement. Centre de guarantie et de service après-vente:
U.S. Robotics
Unit-100, 13751 Mayfield Pl.
Richmond, B.C. Canada V6V 2G9
CE Compliance
We, U.S. Robotics Corporation of 935 National Parkway, Schaumburg, Illinois, 60173-5157 USA, declare
®
under our sole responsibility that the product, U.S. Robotics 56K PC Card Winmodem with XJACK
Connector, to which this declaration relates, is in compliance with the following standards and/or other
normative documents:
EN60950
EN55022
EN55024
We hereby declare that the above named product is in compliance with all the essential requirements
and other relevant provisions of Directive 1999/5/EC.
The conformity assessment procedure referred to in Article 10(3) and detailed in Annex II of Directive
1999/5/EC has been followed.
16
Advertisement
