Advertisement
Would you like to install the Classic PhoneTools software?
Classic PhoneTools software allows your computer to perform the functions of a
fax machine, answering machine, and speakerphone all in one application.
(Answering machine and speakerphone capabilities are only available with voice
modems.) You can also use Classic PhoneTools to connect to another computer,
electronic bulletin board service (BBS), or office network using terminal
emulation.
1.
Insert the Installation CD-ROM into your CD-ROM drive. The Installation CD
window should automatically appear.
If the Installation CD window does not appear, click Windows Start and
then Run. Type D:\setup.exe in the "Run" dialog box. (If your CD-ROM drive
uses a different letter, type that letter in place of D.)
2.
Select Software, PhoneTools, and then Install. Follow the on-screen
instructions to complete the installation of the Classic PhoneTools
software.
Note:
ROM. You can install this software in the same manner that is described
above.
Troubleshooting
Having trouble with your modem? Try these basic
troubleshooting steps first!
Verify that the phone cord is installed correctly.
The phone cord should be plugged into the XJACK connector on the modem
and into the telephone wall jack. Use the phone cord included in your
modem's box, if possible.
Verify that the modem was installed correctly.
Make sure that your modem is physically installed correctly in your
computer. You must press the modem in firmly so that it is seated properly
in the PC card slot.
Next, make sure that the modem's drivers have been installed correctly.
Follow the instructions for your operating system.
6
Additional software may also be included on the Installation CD-
Advertisement
