Schema Quadro Elettrico - Riello RS 70 VA Installation, Use And Maintenance Instructions

The burner has conforms to the basic requisites of the following Directives:
– Electromagnetic Compatibility Directive 89/336/EEC - 2004/108/EEC;
– Low voltage Directive 73/23/EEC - 2006/95/EEC;
– Machine Directive 98/37/EEC;
– Efficiency Directive 92/42/EEC.
and to the technical Standard EN 746-2 - Industrial Thermoprocessing Equipment.
The burner meets protection level of IP 44 according to EN 60529.
IDENTIFICATION
The Identification Plate on the product gives the serial number, model and main technical and performance data. If the
Identification Plate is tamp ered with, removed or mi ssing, the product cannot be clearly identified, thus making any in-
stallation or maintenance work potentially dangerous.
GENERAL WARNINGS
The dimensions and type of the heat generator's combustion chamber must have specific values to achieve combustion with
the lowest rate of pollutant emissions.
You are therefore advised to consult the Technical Assistance Department before choosing this type of burner for the combi-
nation with a boiler.
Qualified personnel are those with the professional and technical requirements indicated by Law no. 46 dated 5 March 1990.
The commercial organisation has a widespread network of agencies and technical offices whose personnel participates peri-
odically in instructional and refresher courses at the Company Training Centre.
This burner must only be used for the application it was designed for.
The manufacturer accepts no li ability within or wi thout the contract for a ny damage to persons, animals or prop erty due to
errors in installation or in the burner adjustment, or due to improper or unreasonable use or non-observance of the technical
instructions enclosed with the burner, or due to the intervention of unqualified personnel.
USER INFORMATION
If faults arise in ignition or operations, the burner performs a "safety stop", which is signalled by the red burner lockout LED.
To rearm start-up conditions, press the reset button. When the burner starts up again, the red LED goes out.
This operation can be repeated for a maximum of 3 times. If the "safety stop" recurs, then the Technical Assistance Centre
must be contacted.
BASIC SAFETY RULES
Children or inexpert persons must not use the appliance.
Under no circumstances must the intake grids, dissipation grids and ventilation vents in the installation room be covered
up with cloths, paper or any other material.
Unauthorised persons must not attempt to repair the appliance.
It is dangerous to pull or twist the electric cables.
Cleaning operations must not be performed if the appliance is not disconnected from the main power supply.
Do not clean the burner or its parts with inflammable substances (e.g. petrol, alcohol, etc.).
The cover must be cleaned with soapy water.
Do not place anything on the burner.
Do not leave containers and inflammable products in the installation room.
The following symbols are used in this manual:
!
WARNING = for actions requiring special care and adequate preparation.
FORBIDDEN = for actions THAT MUST NOT be performed.