2.2.2. Inserting the batteries in the remote control
The remote control is powered by two 1.5V AAA batteries.
To install or replace the batteries:
1. Press and then slide the cover to open
it.
2. Insert the batteries with the correct
polarity (+) and (–).
3. Replace the cover.
Caution:
Incorrect use of batteries may cause leakage or explosion. Be sure to follow the instructions
below:
•
Insert "AAA" batteries with the correct polarity (+ and -).
•
Do not mix battery types.
•
Do not use a new battery with a used one together. Otherwise, it may cause leakage or
shorten the life of the batteries.
•
Remove the dead batteries immediately to avoid battery leakage in the battery compartment.
Do not touch exposed battery acid, as it may cause injury to your skin.
•
Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a
battery, that can result in an explosion; leaving a battery in an extremely high temperature
surrounding environment that can result in an explosion or the leakage of flammable liquid
or gas; and a battery subjected to extremely low air pressure that may result in an explosion
or the leakage of flammable liquid or gas.
NOTE:
Remove the batteries from the battery compartment when not using for an extended
period of time.
2.2.3. Handling the remote control
•
Do not drop or apply shock to the remote control.
•
Do not allow any liquid to get inside the remote control. If water has entered the remote
control, wipe the remote control with a dry cloth immediately.
•
Do not place the remote control near heat and steam sources.
•
Do not attempt to disassemble the remote control, unless you need to place batteries in the
remote control.
7