Advertisement
1. Description
This precision collet chuck is designed for clamping shank tools with a cylindrical shank
up to a tolerance class H8. The base body and clamping nut are made of stainless steel
and are therefore permanently corrosion-resistant against the effects of moisture and
hand perspiration.
Due to the design of the clamping nut with trapezoidal thread and ball bearing slide ring in
combination with the slim taper angle of the OZ collets of 2°52', very high clamping forces
are transmitted to the tool. In addition, the slim design allows better accessibility when
machining angled workpieces.
2. Safety Instructions
Read the instruction manual before using the clamping device!
The clamping devices comply with the safety requirements according to EN 847.
Tools and clamping devices must be handled and operated only by trained and
experienced personnel.
The clamping device must be used only as described in the section "Intended use". Refer
chapter 5.
The applicable national accident prevention and occupational health and safety
regulations should be observed.
2.1
Signal words and Warning symbols
DANGER!
The signal word „DANGER" indicates potential hazards, which will directly lead to serious
injuries or death.
WARNING!
The signal word „WARNING" indicates potential hazards, which may lead to serious or
fatal injuries.
CAUTION!
The signal word „CAUTION" indicates potential hazards, which may lead to minor
personal injuries.
NOTE!
The signal word „NOTE" indicates potential hazards, which may lead to material damage.
For further symbols see chapter 10.
2.2
Sources of danger
Risk of injury / damage due to improper use.
Improper use of tools can result in death or extremely serious personal injury and material
damage.
Observe the safety notes and operating instructions of the tool and machine!
06/2022 ID.525127 V1.0
9
Advertisement
