Advertisement
NOTE!
The tool must be mounted, locked and put into operation in accordance with specifications
of the machine manufacturer.
The maximum values specified by the machine manufacturer for the tool mass, tool
diameter and projection length must be observed.
Before using the tool check cutting parts, clamping screws and clamping elements for
correct and tight fit.
Check the machine settings, especially RPM and direction of rotation!
During assembly, it must be ensured that the tool, as well as all the cutting and mounting
parts are clamped on the intended clamping surfaces.
The cutting edges must not come in contact with fasteners or machine parts.
All clamping surfaces must be free of contamination, e.g. dust, chips, resin, grease, oil
or water.
Extending clamping wrenches or using a hammer is prohibited!
NOTE!
Before running the tool, remove the fastening key and test the idle run.
WARNING!
Improper stopping of the tool, e.g. by lateral pressing, is not allowed.
Risk of damage!
Danger of Kickback!
7. Cleaning and Maintenance
WARNING!
Use appropriate safety gear - Refer to chapter 3.
Health risk!
14
06/2022 ID.525127 V1.0
Advertisement
