Using On-Screen Display (Osd) Controls - Lenovo ThinkVision 27 3D User Manual

Using On-Screen Display (OSD) controls

To adjust the settings, the user controls can be viewed through the OSD�
To use the controls:
1� Press
2� Use or
selected function� If there is a sub-menu, you can move between options using
, then press
to save�
3� Press
4� Press and hold
adjustments to the OSD� Press and hold
allow adjustments to the OSD�
5� Enables DDC/CI by default� Press and hold
DDC/CI function� A message "DDC/CI disable" is shown on the screen�
Note: When you enable the 3D function, the OSD menu only supports adjusting the
volume and brightness; other settings are not adjustable�
27 3D
Brightness 75
Monitor control Contrast 75
Dynamic contrast Off
Over drive Off
Color mode sRGB
Quick settings
Brightness Native On
Relative Gamma Default
Advanced settings
Input signal: HDMI Resolution: 2560x1440
to open the main OSD menu�
to move among the icons� Select an icon and press
to select that function� Use
to move backwards through the sub-menus and exit from the OSD�
for 10 seconds to lock the OSD� This will prevent accidental
Refresh rate: 60Hz
or to make adjustments then press
for 10 seconds to unlock the OSD and
for 10 seconds to disable/enable
Chapter 2� Adjusting and Using your monitor 2-4
to access the
or