Table of Contents
Advertisement
30
Driver
information
display
Resetting the service interval display
Your authorized Audi dealer will reset the cor-
responding service schedule after performing
the appropriate service on yo ur vehicle . You
also have the possibility to reset the oil
change schedule after having performed an
oil change according to Audi specifications.
Select
I
CAR
I
function button >
Service interval
display > Reset oil change interval
or
ICARI
function button>
Car systems*
control but-
ton
> Servicing
& checks > Reset oil change
interval.
(D
Note
If you disconnect the battery terminals, no
calculations can be made for the service
interval display during this time and no
service rem inder wi ll appear. Remember
that observing the proper service intervals
is vitally important to extend ing the life of
your vehicle, particu larly the engine, and
maintaining its value. Even if the mileage
driven is low, the maximum period of one
year from one service to the next must not
be exceeded.
@
Tips
- Do not reset the display between oil
changes, otherwise the display will be in-
correct.
- The information in the Service Reminder
rema ins stored even when the vehicle
battery is disconnected.
On-Board
Diagnostic
system
(OBD)
Malfunction Indicator Lamp (MIL)
The Malfunction Ind icator Lamp (MIL)
¢4'
in
the instrument cluster is part of the On-Board
Diagnostic (OBD II) system.
The warning/indicator
light illuminates when
the ignition is switched on and goes out after
the engine starts and the idle has stabilized .
This indicates that the MIL is working proper-
ly.
If the light does not go out
after the engine
is started, or illuminates while you are driv-
ing, a malfunction may exist in the engine sys-
tem . If the light illuminates, the catalytic con-
verter could be damaged .
Continue driving
with reduced power
(avoid-
ing sustained high speeds and/or rapid accel-
erations) and have the cond ition corrected.
Contact your authorized Audi dealer.
If
the light illuminates, the electronic speed
limiter may also be malfunct ioning. For more
information
c:>
page 31 , Electronic speed
limiter.
An improperly closed fuel filler cap may also
cause the MIL light to illuminate
c:> page 204.
On-Board Diagnostics
Fig. 18 Locat ion of Data Link Connector (DLC)
On-Board Diagnostics monitors the compo -
nents of your emission control system . Each
monitored component in your engine system
has been assigned a code. In case of a mal-
function, the component will be identified
and the fault stored as a code in the control
module memory.
The MIL light may also illuminate if there is a
leak in the on-board fuel vapor recovery sys-
tem. If the light illuminates after a refueling,
stop the vehicle and make sure the fuel filler
cap is properly closed
c:>
page 204.
In order to make an accurate diagnosis, the
stored data can on ly be displayed using spe-
cial diagnostic equipment (generic scan tool
furOBD) .
~
Advertisement
Table of Contents
