Lifting Vehicle - Audi AS Coupe 2014 Owner's Manual

Loading the vehicle onto a flat bed truck
Fig. 193 Vehicle on fla t bed tr uck
Front hook up
.. Align the vehicle with t he centerline of the
car carr ier ramp.
.. Attach the winch hook to the front towline
eye previously installed .
Rear hook up
.. Align the vehicle with the centerline of the
car carrier ramp.
.. Attach the winch hook to the rear towline
eye previously installed.
(D}
Tips
Check carefully to make sure the hook- up
is secure before moving the car up the flat-
bed truck ramp .
Lifting vehicle
Lifting with workshop hoist and with
floor jack
The vehicle may only be li~ed at the lifting
points illustrated .
Fig. 194 Front lift ing point
Emergenc y s itu a tion s 259
Fig. 19 5 Rear liftin g point
.,. Read and heed WARNING
c::>
.&,.
.,. Locate lifting points
c::>
fig.
194 and
¢ fig. 195 .
.,. Adjust lifting arms of wo rkshop ho ist or
floor jack t o ma tch veh icle lifting points.
.. Insert a rubbe r pad bet ween the floor jack/
workshop hoist and the lift ing points.
If you mus t lift your veh icle with a floor jack
to work underneath, be sure the vehicle is
safel y supported on stand s intended for thi s
purpos e .
Front lifting point
The lifti ng point is loca t ed o n the floo r pan re-
inforcemen t abo ut at the same level as the
jack mounting point
c::> fig.
194. Do not lift
the vehicle at the vertical sill reinforcement.
Rear lifting point
The lifting point is located on the vert ica l rein-
fo rcement of t he lower sill for t he on board
jack
c::> fig.
195 .
Lifting with vehicle jack
Refer to
c:;,
page 247 .
A
WARNING
- To reduce the risk of ser ious injury and
veh icle damage.
- Always lift the vehicle only at the spe-
cia l workshop hoist and floor jack lift
points illustrated
c:;,
fig.
194 and
c:;,
fig.
195.
- Failure to lift the veh icle at these
-
po ints could cause the vehicle to tilt or ..,.