Table of Contents
Advertisement
Batteries
Expected life for AA batteries is up to 14 hours (total battery life varies
depending upon battery type and manufacturer)
.
When the LED indicator turns red
,
it signifies "low battery" with
approximately
60
minutes of remaining battery life.
For alkaline batteries only. For rechargeable batteries, solid red means the
batteries are dead.
To remove batteries from the handheld transmitter, push them out through
the opening in the microphone battery compartment.
0
0
WARNING:
Danger of
explosion if battery incorrectly
replaced. Operate only with
Shure compatible batteries.
WARNING:
Battery packs shall
not be exposed to excessive
heat such as sunshine, fire, or
the like.
Locking and Unlocking Controls
Lock system controls to prevent accidental setting changes or power-off.
Transmitter (lock/unlock)
Turn the transmitter on. Hold the
group
button, then press the
channel
button for approximately 2 seconds. The LED indicator rapidly flashes red
when
locked.
Receiver (lock/unlock)
Turn the receiver on. Simultaneously hold the
group
and
channel
button
until the flashing lock icon appears in the lower left-hand corner of the
display, indicating the controls are locked. Repeat to unlock the controls.
Power Off
Press and hold the
power
button to power off the BLX2 or BLX4R. To
power off the BLX1, slide the power switch to
OFF.
Wearing the Bodypack Transmitter
Clip the transmitter to a belt or slide
a guitar strap through the transmitter
clip as shown.
For best results, the belt should be
pressed against the base of the clip.
Removing and Installing Identification
Caps
The BLX2 is equipped with a black
identification cap from the factory
(dual vocal systems ship with
additional gray cap)
.
To remove: Remove battery cover.
Squeeze sides and pull off
cap.
To install: Align the cap and click
into place. Replace battery cover.
An Identification Cap Kit containing
assorted colored caps is available as
an optional accessory.
Rack-Mounting a Receiver
Use the supplied mounting hardware to install the receiver in a standard
19" audio equipment rack.
Antenna Connection Diagram
'
.,-11' : :::;
~
:
.,·"
'
11
Advertisement
Table of Contents
