Table of Contents
Advertisement
..
OCTAVE TRANSPOSE
Normally, all MIDI couplers play at standard pitch (middle C
=
note 60). The Octave Transpose
parameter may be reset to cause any MIDI coupler to play one or two octaves above or below
standard pitch.
1. Hold SET and press the MIDI coupler piston to enter the MIDI Set Mode.
2. While holding SET, turn the SELECf knob four steps clockwise. The cursor will move
to the Octave l"'ranspose parameter.
..... , •••• ,.
•.... ,..
•..··1 I
..
1·1 J. L·· J.
I~]
I
....·r'
J.
.............
.. .......
I 1."·.1
L 1.-·•••......
r·
I~]
1·1
J.
.a::
J.
•...
·1...1
L..
1.1
1 ... 1
r:.I·1
3. Release SET, and turn the SELECf knob to set the parameter. The five available settings
are NORM, UP 1, UP 2, DN 1 and DN 2.
4. Press either the flashing MIDI coupler or General Cancel to revert to the Transposer.
The Octave Transpose setting is included in the parameters which may be stored on a
combination piston.
SAVING COUPLER PARAMETERS ON COMBINATION PISTONS
Once the parameters for a MIDI coupler have been set, these parameters will be saved on any
combination piston on which the coupler is set. These parameters will then be restored to the
coupler any time the piston is activated. Thus, the same coupler may be set to control different
voices on different pistons by setting the Channel (GT only), Program Change, VolumeNelocity
Mode and Octave Transpose before setting each piston. This is easily accomplished, since pistons
may be set while MIDI Set Mode is activated, and the coupler parameters are being displayed.
ENABLING/DISABLING MIDI MASTER CHANNELS
The following MIDI channels are used to control the OXFORD 940 through MIDI:
Great Master Channel
12
Swell Master Channel
13
Pedal Master Channel
14
Ch/Pos Master Channel
15
The organ sends and receives MIDI information on these channels unless they are disabled.
19
Advertisement
Table of Contents
