Rodgers 940 Manual page 24

EXPRESSION/VELOCITY MODE TOGGLE
The Velocity Mode may be set or reset for each MIDI coupler. Velocity is controlled by the
associated expression pedal.
1. Hold SET, and press the MIDI coupler. The piston will flash. Release both pistons.
2. Hold SET, and turn the SELECT knob three steps clockwise. The cursor will move to
the VolumeNelocity parameter.
3. Release the SET piston, and turn the SELECf knob again to choose between the two
modes.
4. Press either the flashing MIDI coupler or General Cancel to revert to the Transposer.
When entering the Velocity Mode, the main volume for the coupler's assigned channel will be set
to maximum and will remain at maximum until the Volume Mode is restored. Likewise, in Volume
Mode, the velocity value sent for all notes is 64 (mid-range). This default velocity may
be
altered
from the MIDI TRANSMITIED VELOCITY menu item.
SETTING MIDI DEFAULT VELOCITY
1. Hold SET, and turn the SELECT knob until the MIDI TRANSMITTED VELOCITY
menu item is displayed.
2. Release SET, and use the SELECf knob to set the desired velocity. In Volume Mode,
this is the velocity which will be sent for all notes. The default MIDI velocity value
selected will
be
retained when the organ is turned off.
CHANNEL REASSIGNMENT
All MIDI couplers transmit on fixed channels except MIDI ON GT. To reset the transmit
channel for this coupler only:
1. Hold SET and press the MIDI ON GT coupler piston to enter the MIDI Set Mode.
2. While holding SET, turn the SELECf knob one step clockwise. The cursor will
move to the channel number.
3. Release SET, and turn the SELECf knob to set the desired channel number.
4. Press either the flashing MIDI coupler or General Cancel to revert to the Transposer.
The channel number for this coupler is included in the parameters which are stored on a
combination piston.
18