Yamaha SR250G Service Manual page 63

Inspection
Inspect the inner tube for bends or scratches.
If the bend is slignt, it can be corrected with
2 press. It is recurnmended, however, to re-
place the tube
Assembly
1. When assembling the front fork. reverse
the order of disessembly.
2. Installing the front forks
a. Bring up the front fork to the correct
position and partially tightan the und
brackst mounting dolt.
b. Measure ccrrect amount of oil nnd pour
into each leg.
Recommendec oil
Yamaha fork oll 10Wror
equivalent
Quantity perieg: 168 cc (5.7 U.S oz)
NOTE:
Sclect the weight ail that suits loce! condi-
tions end your preference (lighter for less
damping; heavier for more damping)
3. After filling, slowly pump the outer
tubes up and down to distribute the o}
4. Inspect "O" ring on fork cap bolts and
replace il damaged,
5. Tighten all pinch bolts with specified
torque
Tightening torque:
Innor tube to handle crown
(upper bracket):
2.0 mekg (14.4 ft-lb)
Inner tube to under bracket:
2.0 ekg (14.4 ftelb)
STEERING HEAD
Adjustment
Reler to Chapter 2, Section 2-12, for steer-
ng Nead adjustment procedure.
Disassembly
1. Remove the seat end 'ue! tenk
2. Remove the frant wheel end
fender
3. Remove the front forks.
4, Remove the headlight stay with
headlight, horn and flasher lights and
put them aside
meter bracket
front
5. Remove the with the
speedo and tacho-meter.
6. Remove the handlebar with load wires
and cables end put them aside
7 Remave the upper bracket and main
switch
&
"
9. Remove the steering ring nut with the
steering nut wrench