Table of Contents
Advertisement
Imake va ve (Cold
0.05 -~ 0.10 mm (0.00? ~ 0.004 in)
Fxhanst valve (Cold)
0,12
~ 0.17 mm (0.005
-~ 0.907 in)
7. Loosen the valve adjuster lock nut, Turn
thw aujuster in or out to obtain the cor-
rect clearance. Hold the adjust2r to pre
vent
and. thoroughly
tighten the lock nut
Recheck the clearance
it from moving
(or tightening.
NOTE; -
Valve clearance check and adjustment
shaule b¢ dene when the engine is cold
covers enc lef: crankcase cover:
9. Invall the fuel tark and sear
10. Gonneer
the fie! pipe.
CHASSIS
Fuel Petcock
First, drain out the fuel <ank
and move
the fue! pipe.
Loosen the fuel cock securing bolts
'and romove the fuel cock assembly
from fuel tank.
Clean the attached filter with sulvent.
Examing thy fille: and replace it dem-
ages
cot the gesker, revlave
and install the outlet fitting.
la naged
Front Brake and Wheel
Front Brake Adjustment
The front orake should bu adjusted
iv suil
nicer preterence within 2 5 -~ B mm (G2 -~
03 in) "es play at the lever oivat side. Ad-
no
s accomplished al ene 0
two
laces; either the hendlebar lever holder or
the front brake hub
Loosen the
lock nut
Tum the cable length adjuster in or out
until adjustment is suitable
Jighten the lock nut
If proper adjustment can not be
Bu
ublained at the randiebar lever holder,
make a brake hub adjustment
28
Advertisement
Table of Contents
