Toro 78479 Operator's Manual page 15

2. Remove the 2 torx-head bolts and 2 nuts from
the left, rear guard
Note:
Perform the step above on 1 side of the
machine, then the other.
Figure 12
1. Left, rear guard
2. Nut
3. Loosely secure the left, upper bracket to the left,
rear guard and upper support using 2 hex-head
bolts (5/16 x 3-1/4 inches), 2 plain washers, 2
flange nuts (5/16 inch), 1 flange-head bolt (3/8 x
1-1/4 inches), and 1 locknut (3/8 inch) as shown
in Figure 13.
Note:
Perform the step above on 1 side of the
machine, then the other.
Figure 13
1. Left, rear guard
2. Flange nut (5/16 inch)
3. Locknut (3/8 inch)
4. Upper support
(Figure 12).
3. Torx-head bolt
5. Flange-head bolt (3/8 x
1-1/4 inches)
6. Left, upper bracket
7. Plain washer
8. Hex-head bolt (5/16 x
3-1/4 inches)
4. Loosely secure the lower support to the engine
plate using 2 carriage bolts (5/16 x 2-1/4 inches),
1 backer plate, and 2 flange nuts (5/16 inch) as
shown in
Note:
Perform the step above on 1 side of the
machine, then the other.
g341515
1. Backer plate
2. Carriage bolt (5/16 x 2-1/4
inches)
5. Tight all the fasteners.
g341516
15
Figure 14.
Figure 14
3. Lower support
4. Flange nut (5/16 inch)
g341517