11.
Join the upper and lower tubes with 3 bolts (#10
x 3/4 inch), flat washers, and locknuts as shown
in
Figure
45.
Figure 45
1. Lower tube
2. Upper tube
3. Flat washer (7/32 inch)
12.
Install the lower tube onto the blower housing
and secure it with the latches.
g003392
4. Locknut (#10)
5. Bolt (#10 x 3/4 inch)
14
Checking the Tire Pressure
No Parts Required
Procedure
Note:
Increase the tire pressure due to the additional
weight.
Maintain the air pressure in the front and rear tires
at 90 kPa (13 psi). Uneven tire pressure can cause
uneven cut. Check the tires when they are cold to get
the most accurate pressure reading.
31
Figure 46
g001055