Launch Creader Professional 919 MAX Manual page 5

LAUNCH
FCC Statement
FCC ID: XUJX431PROV5
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
highest reported SAR for stand-alone and simultaneous transmission exposure
conditions are below the maximum value. End-users must be informed of the
operating requirements for satisfying RF exposure compliance.
This device is in compliance with the essential requirements and other relevant
provisions of Radio Equipment Directive 2014/53/EU. The RF frequencies can
be used in Europe without restriction.
v