JMK CLOCKstep:MULTI Manual page 21

CLOCKstep:MULTI
External Clock Sync (con nued)
Striping a Tape
Another sync made possible with CLOCKstep:MULTI is striping a mul -track
recorder with clock data.
CLOCKstep:MULTI's Line Audio Output, which is normally used to send Click
Audio, can be re-purposed to send 24 PPQN audio clock instead. See the Audio
Sync OUT Enable feature in Global Se ngs.
Record this output onto a new track of a mul -track machine at the desired
BPM. When finished, disconnect CLOCKstep:MULTI from the recording input.
During playback of the tape, route the clock track that you recorded back into
the Line Audio Input of CLOCKstep:MULTI. Just as with the Sample Accurate
Clock method, CLOCKstep:MULTI will respond by using this audio as its clock
source. You can record new tracks while monitoring the Click Audio and
synchronizing external gear.
Synchronizing Two CLOCKstep:MULTIs
The Audio Sync Out Enable feature can also be used to synchronize 2
CLOCKstep:MULTIs without using MIDI Clock. Just set one of the units to send
the 24 PPQN signal from its Line Audio Output and the other unit to receive
that signal on its Line Audio Input.
Other Uses
CLOCKstep:MULTI will coordinate with any device capable of either sending or
receiving 24 PPQN audio clock. There's nothing proprietary about the audio
clock signal; it's as plain vanilla as it gets.
Copyright 2023 JMK Music Pedals
version 1.0 (build 0050)
View Tape Sync Video
JMK MUSIC PEDALS
21