Table of Contents
Advertisement
6. REHEARSAL
PROGRAMMING
AND
AUTO
IN/
OUT PROCEDURES
Programmed Rehearsal of Inserts (RHSL)
18
meter and output from tape to source and back again,
but
won't
actually
record.
What
you
hear
in your
monitor mix will be the same as during recording; so if
the first in-out points aren't correct, you'll hear it and
can CLEAR the old points and try again until you've got
exactly what you want.
CAUTION:
Although the advanced
circuitry of the
TSR-8 allows gapless punch-in on the tape, there is still
the distance between
the erase and record heads to be
compensated
for. Depending
on tape speed, the time
from a punch
point to the actual in/out is 1/15th or
1/8th of a second.
A few practice runs will get you
accustomed to the timing of punching in.
Entering the Automatic Preroll and Punch-In/Out Points
NOTE:
!f you want to quit what you are doing at
any time during the following procedures, press CLEAR.
1. Press the Record
Enable button of the track you
want to punch-in on. Its LED will start blinking. Check
to make sure that all other tracks are in safe mode.
3. Press the INSERT switch. Its LED will light.
5. Press PLAY.
That point on the tape will be put
into memory defined as the preroll start point.
6. At the
punch-in
point,
press
RECORD
or the
footswitch.
Your
punch-in
point
will
be
put
into
memory. The track's record LED will light steadily, but
the
master
RECORD
LED
will
blink,
showing
that
recording is not actually taking place.
7. Press
PLAY
or the footswitch
when
the
tape
reaches
the
punch-out
point. That
point will
be put
into memory. The LED for the selected track will start
blinking and the RECORD
LED will turn off.
8. After a 3-second postroll, the RHSL
LED will go
on
solid,
while
the
tape will automatically
rewind,
stopping at the preset start point.
The TSR-8
is now in
Rehearsal Ready mode.
Preroll (of
Postroll
the desired
(fixed to
duration)
Punch-in Segment
3 sec.)
IN
OUT
Auto Rewind
Advertisement
Table of Contents
