Tascam TSR-8 Operation & Maintenance Manual page 27

TAPE TIME
MEMO location can be used if the TSR-8 is in RHSL
or AUTO IN/OUT mode. Both MEMO points are erased
when power is turned off.
if the RESET button is pressed, and the counter is set
to 00.00, the 'two MEMO points are automatically
recalculated, so they stay the same relative to their
original tape position,
2) CHECK Button
When the CHECK button is pressed, the digital
counter shows a broken line. Pressing then the MEMO
1 or 2 button causes the counter to show, for as long as
the MEMO button is held pressed down, the content of
the corresponding register. As you release the MEMO
button, the counter
again shows the broken line. A se-
cond press
of CHECK, switches
the counter
to the
original display (Tape Run Time).
Pressed Pressed Released Pressed
> Gee > > Eee > Be)
3) LOC 1 and LOC 2 Buttons
Pressing either of these buttons causes the tape to roll
(in either F.FWD or REW) to the corresponsing MEMO
point. The tape will stop when
it reaches the MEMO
point.
If the AUTO
PLAY feature
is used together,
the TSR-8 will
enter automatically
Play mode
after
reaching the memorized point.
4) REPEAT 1-2 Button
The REPEAT function provides a ''Playback Loop"
or "Block Repeat' between the two programmed
MEMO points. Note that MEMO 2 does NOT have to be
a number greater than MEMO 1. When REPEAT is-
enabled and the current tape location is between the two
MEMO points, the tape will play to the higher MEMO
location, rewind to the lower MEMO location and start
over. This cycle will repeat until STOP, or any other
transport button is pressed.
TASCAM TSR-8
Auto Locator
Section (#26)
5) RTZ (Return to Zero) Button
6) AUTO PLAY Button
27. EDIT Button
1) Manual Edit
v\,
Cueing out the edit points
29